Teletronics EZPlatform Bedienungsanleitung PDF herunterladen (Seite 38)

6. Console and TELNET Access

If for any reason you cannot access the EZPlatform™ via the web interface, you may still be

able to recover the unit via the console (serial port) or TELNET. The console and TELNET offer

the same options and commands, the only difference being the way they are accessed.

To access the EZPlatform™ via the console, connect the serial cable EZPlatform™ to a

computer using a serial cable. Use the serial port in the EZPlatform™ that is closer to the

Ethernet ports. In the computer, open a HyperTerminal window or similar program. In Microsoft

Windows, the HyperTerminal can be located at Start Æ Programs Æ Accessories Æ

Communications Æ HyperTerminal. Configure the HyperTerminal to connect to the

EZPlatform™ with the following settings:

 Bits per second: 115200

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

To access the EZPlatform™ via TELNET, open a terminal and type ‘telnet <IP address>’,

substituting ‘<IP address>’ for the actual IP address of the EZPlatform (e.g.: telnet

192.168.1.124). After the connection has been established, enter your user name and password.

Whether you are using the console or TELNET, you should see the same set of options once

you access the EZPlatform™. These options allow you to view your network settings, reset the

EZPlatform™ to factory defaults and reboot the unit, as shown in Figure 25. These commands

are especially useful if you have forgotten the IP address of the EZPlatform™ and/or your

password.

Figure 25. Console and TELNET options

1 2 ... 33 34 35 36 37 38 39 40 41

Keine Kommentare

Teletronics EZPlatform Bedienungsanleitung Seite 38